DeusVultLux

Set the job on a full touchscreen.

Laser power, wobble, wire mode and head temperature sit on one screen at eye level. Below it, the illuminated cross shows the unit's state from across the bay.

• DisplayColor touchscreen
• StatusIlluminated cross + LED bar
• SafetyOn-screen safety lock

Round vents on both flanks.

Each side carries a full circular grille cut with a field of crosses, with the Deus Vult Lux medallion at its centre. Air moves straight through the body, so the unit can sit against a wall on either side.

The head docks on the side, cable coiled behind it.

The welding head rides in a holster on the unit, with its cable stored on the wrap. Pick it up, pull the trigger, and the wire bracket feeds filler right at the nozzle.

• NozzleCopper tip, swappable
• OpticsPull-out protective and focus lens drawers
• WireHead-mounted wire bracket

Every connection on one labeled panel.

Single-phase 208–240 V power, ground, network and wire feed all land on the back, each with its own printed label, so setup on a new site takes minutes.

• HWI
• WIRE FEEDER
• CLAMP
• LAN
• AC 208–240V

A Milwaukee Packout base on the lid.

A 14-gauge sheet-metal Packout base is bolted to the top of the shell. Lock a Packout organizer or tool box onto the welder and roll the whole stack to the job.

• Base footprint18.8 × 13 in
• Profile height0.6 in
• Material14 ga sheet steel

Click a drawer box on. Lift it off at the job.

A Packout 3-drawer tool box locks onto the base and comes off with its side latches. Keep nozzles, protective lenses and filler wire in the drawers, then carry the box to the work and leave the welder parked.

• Box22.1 × 16.2 × 14.3 in
• Drawers3, full width
• MountPackout interlock, red side latches